Kelvinator Excessive Frost in Johannesburg
Excessive frost — more than a thin, even coating — indicates the defrost cycle can't keep up, usually because the heater, limit switch or sensor has failed, or because a door seal is admitting humid air. Our independent technicians diagnose and repair the underlying cause.
01Defrost cycle failure
If the heater never energises, or the limit switch never closes, frost accumulates faster than the cycle can clear. We test each component.
02Air ingress
Humid air entering through a failed seal condenses and freezes, overwhelming the defrost system. We test the seal alongside the defrost components.
03Independent service
Independent Kelvinator specialists serving greater Johannesburg. Not affiliated with the manufacturer.
Frequently asked questions
How much frost is too much?
A thin, even frost is normal; thick, layered frost or ice blocks are not — they signal a fault.
Will defrosting fix it?
Temporarily only. The failed component must be replaced to stop the frost returning.
Is this the same as an ice build-up fault?
Closely related — both point to the defrost system or seals. We diagnose the specific failed part.