Kelvinator Ice Build-Up in Johannesburg
Frost and ice build-up in a frost-free Kelvinator is a symptom, not a cause — it means the automatic defrost cycle has failed or warm air is entering. Our independent technicians identify whether the fault is the defrost heater, limit switch, timer, sensor or door seal, and repair the root cause.
01Where ice forms matters
Ice on the evaporator points to a defrost fault; ice around the door points to a seal fault; ice in the freezer base points to a blocked drain. Location guides diagnosis.
02Don't just chip it away
Forcing ice off can puncture the evaporator and write off the unit. A manual defrost may temporarily help, but the failed component must be replaced.
03Independent service
Independent Kelvinator specialists serving greater Johannesburg. Not affiliated with the manufacturer.
Frequently asked questions
Is ice build-up normal?
In frost-free Kelvinator models, no — it signals a defrost or seal fault. Manual-defrost units need periodic defrosting.
Can I scrape the ice off?
Never use sharp tools — you can puncture the evaporator. A gentle manual defrost is safer, but the fault will recur until repaired.
What causes ice around the door?
Usually a perished or warped door seal admitting moist air. We test and replace the seal.